TECHNICAL DATA

NIF 65

HIGH PERFORMANCE EPOXY COATING

PRODUCT DESCRIPTION: CURE SCHEDULE: (70 f)

NIF 65 is a two component solvent based pot life -2 gallon volume…3-5 hours

epoxy coating that exhibits excellent characteristics tack free (dry to touch)…2-4 hours

for abrasion resistance and substrate penetration. Recoat or topcoat…4-6 hours

This product is suitable as a primer for high build light foot traffic…16-24 hours

Coatings and urethane or as a stand alone coating. Full cure (heavy traffic)…2-7 days

RECOMMENDED FOR: APPLICATION TEMPERATURE:

Recommended for priming or coating concrete, wood, 40-90 degrees

or steel. This product can withstand exposure to many

common solvents and chemicals. VISCOSITY:

mixed = 300-500 cps (typical)

SOLIDS BY WEIGHT:

Mixed = 65% (+, - 2%) CHEMICAL RESISTANCE

REAGENT RATING

SOLIDS BY VOLUME: acetic acid A

Mixed = 52% (+, -2%) xylene B

Mek A

VOLATILE ORGANIC CONTENT: gasoline B

Part A = 3.43 pounds per gallon 10% sodium hydroxide E

Part B = 3.75 pounds per gallon 50% sodium hydroxide D

10% sulfuric C

COLORS AVAILABLE: 10% hydrochloric acid C

White, off white, light gray, medium gray, 20% nitric acid A

Dark gray, charcoal gray, title red, brown, ethylene glycol C

Tan, beige, light blue, blue, green, and

Special colors upon request. PRIMER:

None required

RECOMMENDED FILM THICKNESS:

5-6 mils per coat wet thickness (yeilds 3 mils dry) TOPCOAT:

optional - Mnay products are suitable

COVERAGE PER GALLON: as topcoats including multiple coats of

267 to 320 square feet at 5-6 mils wet thickness this product. For added chemical

resistance, color stability or UV

MIX RATIO: stability, topcoat with a suitable

1 part A to 1 part B by volume aliphatic urethane.

PACKAGING INFORMATION: DOT CLASSIFICATION:

2 gallon and 10 gallon kits (volume approx.) part A "FLAMMIBLE LIQUID N.O.S.

2 gal kit = 1 gallon part A (8.5 # /gal) and 1 gal 3, UN1993, PGII"

part b (11.0 # /gal) (weights approximate) part B "FLAMMIBLE LIQUID N.O.S.

3, UN1993, PGIII"

SHELF LIFE:

1 year LIMITATIONS:

* Colors may be affected by high

FINISH CHARACTERISTICS: humidity, low temperatures, or

Satin gloss (30-60 at 60 degrees at Ericheson glossmeter) chemical exposure.

* UV light exposure can cause slight

ABRASION RESISTANCE: discoloration.

Taber abraser CS-17 calibrase wheel with 1000 gram * For best results use a 3/8" nap roller.

Total load and 500 cycles = 30.2 mg loss * Slab on grade requires moisture

Barrier.

IMPACT RESISTANCE: * Substrate temperature must be

Gardner impact, direct + 50 in.lb. (passed) 5 degrees F above dew point.

* All new concrete must be cured for

FLEXIBILITY: at least 30 days.

No cracks on a 1/8' mandrel * product color will vary from batch to

Batch.

ADHESION: * physical properties are typical values

375 psi at elcometer (concrete failure, no delamination) and not specifications.

* light or bright colors (white, safety

yellow, ect.) may require multiple

coats or a topcoat to achieve a

satisfactory hide, depending on the

substrate.