nifcru_mixing_application_instr

N.I.F. CRU

_______________________________________________________________

MIXING AND APPLICATION INSTRUCTIONS

1) Store product in an area so as to bring the material to normal room temperature before using.

2) Mix part A and part B together thoroughly using slow speed mixing equipment or by hand mixing in order to minimize air being whipped into the coating.

3) Make certain that the substrate where the product is to be applied is clean, sound and free of all laitance, dirt, dust, oil, grease, or foreign contaminants. Be absolutely sure that the substrate is completely dry.

4) Make certain that the floor temperature and air temperature are within the recommended ranges before applying the product.

5) This product may be applied by roller, brush or spray. Be sure to apply this product at the specified coverage rate or recommended mil thickness. Be certain to use an appropriate primer or basecoat before applying this coating. When applying coatings that are light in color or bright, additional coats of this product or an appropriate colored primer may be necessary.

6) Allow sufficient time between coats. Because this material has such a high gloss and film hardness coupled with the fact that it is a urethane, it may be necessary to slightly roughen the surface between coats to insure trouble free multiple coat applications. We recommend topcoating or recoating within 24 hours after the initial application. If conditions (weather, temperature, air movement, high humidity etc.) do not facilitate complete air release from within the applied coating, then you must use an air release roller tool prior to the surface tacking off to eliminate the resultant possible surface defects.

7) Always check the previous coat for foreign contamination before recoating. Clean or prepare the preceding coat if an inspection so warrants before applying any additional coats.

8) Take notice of the full cure time and do not open the area to harsh industrial chemicals or abusive use before the full characteristics of the coating is achieved.

9) Provide routine maintenance to assure years of trouble free performance.

NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND LIMITATIONS OF OUR LIABILITY.

We warrant that our product is manufactured to the specifications as stated here or in other publications. All other information supplied by us is accurate to the best of our knowledge. Such information supplied about our products is not a representation or a warranty. It is supplied on the condition that you shall make your own tests to determine the suitability of our product for your particular purpose. NO WARRANT IS MADE, EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION, THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN FROM ITS USE. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT INFRINGE UPON ANY PATENT. We shall have no liability for incidental for consequential damages, direct or indirect. Our liability is limited to the net selling price of our product or the replacement of our product, at our option. Acceptance of delivery of our product means that you have accepted the terms of this warranty whether or not purchase orders or other documents state terms that vary from this warranty. No representative is authorized to make any representation or warranty or assume any other liability on our behalf with any sale of our products. Uncured epoxy resins, polymers and their curing agents my be ALKALINE, TOXIC or BOTH, depending on the particular system. They may cause ALLERGIC REACTIONS or HYPERSENSITIVE REACTIONS. BEFORE USING any material, READ THE MATERIAL SAFETY DATA SHEET AND FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.