MIXING AND APPLICATION INSTRUCTIONS
WATER BASE EPOXY PRIMER

PRODUCT MIXING: This product comes prepackaged by weight. Kits should be mixed in their entirety. After the two parts are combined, mix well with slow speed mixing equipment such as a jiffy mixer until the material is thoroughly mixed and streak free. This product is an emulsion product and should be mixed well before using.

PRODUCT APPLICATION: The mixed material can be applied by brush, roller or spray. Maintain temperatures within recommended ranges.

DRY TIME: Light foot traffic, 16-24 hours at 70 degrees F.


CONCRETE PREPARATION FOR FLOOR COATING:

Acid etching solution will not work properly on greasy, oily, or painted surfaces. This concrete must first be cleaned with either, Northern Aqua-Blue or Northern Scrub-Free, for heavy film buildup removal.

Acid solution should always start at lowest level of a floor, usually the drains. Apply in a circular fashion out away from drains. Remember acid solution will not work properly when poured on "spent" or "used" acid solution. Acid solution should "foam" or "froth" instantly when poured on the concrete. Slow or no reaction is a sign the concrete was not ready to be etched. Clean and repeat above procedure.

Muratic and hydrochloric acids are available commercially at most hardware or pool supply stores. Mix 2 parts water with 1 part acid for good etching. Using a plastic watering sprinkler, apply the mixed acid solution (always add water to the can first) at a spread rate of 50 sq. ft. per gallon. Acid solution must be "worked" into the substrate with a stiff bristle broom to completely agitate the floor. Once acid solution stops frothing (approximately 10-15 minutes) flush the remaining solution to drain and rinse floor thoroughly. "Do not let solution dry". Rinse floor a second time with some household ammonia to neutralize any acid residue that might remain.

MIXING AND APPLICATION INSTRUCTIONS
MEGA-BUILD EPOXY

PRODUCT MIXING: This product has a mix ratio of two parts A to one part B by volume. Standard packaging is 3 gallon and 15 gallon units. After the two parts are combined, mix well with slow speed mixing equipment such as jiffy mixer until material is thoroughly mixed and streak free.

PRIMER: A suitable primer should be used before applying this product. Northern waterbase epoxy is recommended.

PRODUCT APPLICATION: The mixed material can be applied by brush, roller, or spray. A serrated squeegee may also be used, then backrolled with a roller to smooth out the floor.

DRY TIME: Light foot traffic in 12-14 hours at 70 degrees F.


CONCRETE PREPARATION FOR FLOOR COATING:

Acid etching solution will not work properly on greasy, oily, or painted surfaces. This concrete must first be cleaned with either, Northern Aqua-Blue or Northern Scrub-Free, for heavy film buildup removal.

Acid solution should always start at the lowest level of a floor, usually the drains. Apply in a circular fashion out away from drains. Remember acid solution will not work properly when poured on "spent" or "used" acid solution. Acid solution should "foam" or "froth" instantly when poured on the concrete. Slow or no reaction is a sign the concrete was not ready to be etched. Clean and repeat above procedure.

Muratic or Hydrochloric acids are available commercially at most hardware or pool supply stores. Mix 2 parts water to 1 part acid for good etching. Using a plastic watering sprinkler, apply the mixed acid solution (always add water to the can first) at a spread rate of 50 sq. ft. per gallon. Acid solution must be "worked" into the substrate with a stiff bristle broom to completely agitate the floor. Once acid solution stops frothing (approximately 10-15 minutes) flush remaining solution to drain and rinse floor thoroughly. "Do not let solution dry". Rinse floor a second time with some household ammonia to neutralize any acid residue that might remain.