MIXING AND APPLICATION INSTRUCTIONS
NORTHERN FLEX-FILL

PRODUCT MIXING: It is important that the material is mixed well. Therefore take a few extra minutes to make sure adequate time has been taken to mix the two components together thoroughly. Improper mixing will cause an incomplete cure and soft spots in the joint. Mix one part (by volume) Part A to one part (by volume) Part B in an oversized container. Mix well with slow speed mixing equipment until totally streak free, being sure to scrap the sides and the bottom of the mixing container thoroughly.

PRODUCT APPLICATION: Apply the mixed material by pouring into the expansion joint to be repaired. Removing any access with a putty knife or similar tool prior to curing. Or you may allow product to cure or become tack-free and shave off excess with a razor scraper.

DRY TIME: Light foot traffic, 16-24 hours at 70 degrees F.



MIXING AND APPLICATION INSTRUCTIONS
NORTHERN CRACK-FILL

PRODUCT MIXING: This product has a mix ratio of one Part A to one Part B by volume. Using a slow speed mixer blend equal amounts of product thoroughly or until streak free.

PRODUCT APPLICATION: The mixed material can be applied with a marginal trowel, putty knife or any other suitable equipment.

DRY TIME: Light foot traffic 10-24 hours at 70 degrees F.